Quick Start Guide

Screw and Anchor
Pack ×1
Camera ×1
Version 1.1.0
Quick Start Guide
1.2.51.32.17527-000
Mounng Template ×1
QSG ×1
Mounng Bracket ×1
Camera Introducon Installing CameraSeng up CameraPackage Content
LED Indicator Status Device Status
Power off/LED turned off
Reboong aer reset
Boong
Device malfuncon
Network connecon failed
Pairing falied
Ready for network configuraon
Ready to pair
Off
Solid red
Flashing green and red alternately Updang firmware
Operang properly
Flashing red
Solid green
Flashing green
Waterproof Connector ×1
Camera
Mounng Screw
Mounng Bracket
Mounng Template
(U-shaped)
Wall Anchor
Mounng Surface
Select Wi-Fi
Wi-Fi XXXXXX1
Wi-Fi XXXXXX2
Wi-Fi XXXXXX3
...
Wi-Fi Password
Lens
IR
LED Indicator
Spotlight
Infrared LED
Microphone
Reset Buon
Micro SD Card Slot
Ethernet Port
Power Port
If the LED indicator status goes wrong, reset the camera.
Make sure that the mounng surface is strong enough to hold at least
three mes the weight of the camera and the bracket.
See the table below for definions of camera’s LED behaviors.
Follow the steps below to add the camera to your Imou account.
Step 1 Scan the following QR code or search "Imou Life" in Google Play or
App Store to download and install the app.
Step 2 Launch the app. Then create an account if you are a new user.
Step 3 Connect the camera to power source with the power adapter.
Step 4 Aer the camera boots up, the LED indicator light flashes green
(wire-free camera) or is on solid green (wired camera).
Step 1 Peel off the U-shaped mounng template and sck it to the desired
installaon area.
Step 2 Drill holes into the mounng surface as the mounng template
marks and then insert wall anchors as needed.
Step 5 Follow the on-screen prompts to add the camera. Repeat the
adding process if you have mulple cameras.
Speaker
Wi-Fi Antenna
Ceiling Mount
If you already use the app, make sure that you are using the latest
version.
Press and hold the reset buon for 10 s to reset the camera.
Double-press the reset buon to enable camera’s hotspot.
Disconnect the camera from the power before installaon or taking
out its SD card.
1
2
3
4
5
Power Adapter ×1

Summary of content (2 pages)