User Manual

6
Attached
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01.
2.2 List of applicable FCC rules
FCC Part 15.203
FCC Part 15.207
FCC Part 15.209
FCC Part 15.247
2.3 Specific operational use conditions
This transmitter/module and its antenna(s) must not be co-located or operating in
conjunction with any transmitter. This information also extends to the host manufacturer’s
instruction manual.
2.4 Limited module procedures
This module is intended for OEM integrator. The OEM integrator is still responsible for the
FCC compliance requirement of the end product which integrates this module. 20cm
minimum distance has to be able to be maintained between the antenna and the users for
the host this module is integrated into. Under such configuration, the FCC radiation exposure
limits set forth for an population/uncontrolled environment can be satisfied. Antenna used
should be limited to same type with equal or lesser antenna gain.
According to FCC Part 15 Subpart C Section 15.212, the radio elements of the modular
transmitter must have their own antenna. However, due to there is no antenna for this
Module, this module is granted as a Limited Modular Approval. When this Module is installed
into the end product, a Class II Permissive Change or a New FCC ID submission is required to
ensure the full compliance of FCC relevant requirements.
2.5 Trace antenna designs
It is “not applicable” as trace antenna which is not used on the module.
2.6 RF exposure considerations
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.This compliance to FCC radiation exposure limit for an
uncontrolled environment, and minimum of 20cm separation between antenna and body.
The host product manufacturer would provide the above information to end users in
their end-product manuals.
2.7 Antennas
Spring antenna; 0dBi; 902MHz~928MHz.