Snap 11S BATTERY CAM ORIGINALITY DESIGN SMART - AND BEAUTIFUL QUICK GUIDE
What's in the box Please consult this checklist for all parts.
Speaker Status light Microphone Lens Photosensitive PIR Reset Micro USB Charging indicator Power button SD card slot Power port DC 5V±10% Power on/off Press the button for 3 seconds to turn on/off the camera Status light Solid red light on: the camera is turning on or malfunctional Blinking red light: awaiting WiFi connection (slowly blinking) connecting the WiFi (quickly blinking) Blinking blue light: currently connecting Solid blue light on: the camera runs correctly SD card slot Support local S
Install Mode 1 Bracket (A) Installation 1.Fix the bracket on the wall with screws 2.Bring the camera closer to the bracket Mode 2 Bracket (B) Installation 0~360° 0~90° After ajusting your camera angle, please lock this screw 1.Fix the bracket on the wall 2.
Connect Download Smart Life is available for both iOS and Android OS. Rearch the name 'Smart Life'in App Store or Android Market, or scan the QR-Code to download the App. ·Support IOS Android Download App(IOS&android) Set up router The router supports the 2.4GHz WiFi (doesn't support the 5GHz).Before connecting to the WiFi network,please set the parameters of the router, and record the SSID and password of your WiFi. Please keep network available 2.
Registration process Step 1 Open the Smart Life App, click "Register", read the "Privacy Policy" and click "Agree" . Step 2 Input a legal and valid Mobile number or Email address and click "Continue". Input Verification Code, then log in the app.
QR Code Configuration 1 Open the Smart Life App, click "Create family", and you can customize the Family name and related settings. 2 Continue to click "Security & Sensor" >> "Smart Camera", and then choose" Add Device" or "+", ready to add camera.
3 In "Add Device" this interface,continue to click "next step", and then you should input your WiFi's passwords. Note: 1) Camera only supports 2.4GHz WiFi network. 2) The number of bits in the ssid and passwords of the router should not exceed 24 digits.
4 In this interface, you should scan the QR code in your phone with the camera, when the camera comes out "dong dong dong". And you can complete the configuration about 30s.
5 When connecting, you should make sure your router, mobile,and camera are as close as possible. When camera added successffully, click " " you could also DIY the camera's name.
Settings In "Smart Camera" interface,click " ",you can set the camera common functions.
FAQ Q: The device cannot be previewed properly? A: Check whether the network is normal, you can place the camera close to the router, and if not, it is recommended to reset the device and add it again. Q: Why is it still in the list of devices after reseting? A: The reset device only resets the network configuration of the camera, but cannot change the configuration on the App, remove the camera, and must be deleted by the App.
Functions Remote wake-up The camera will be in a sleep mode to save power; you can have a preview in App. Full-duplex audio You can see and hear the vistor in your App from the camera. PIR When the camera detects someone stopping by, it sends an alarm message to your cell phone. Low battery alarm When the battery power is lower than your set, the App will send a notification to your mobile phone. Record Using SD card or opening the Cloud-Storage Service, to keep recording for every moment.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
