Owner's Manual

ManualsBrandsHangzhou Samko Electronics ManualsElectronicsFDBT, PWBT

PWBT-FDBT OWNER’S MANUAL

Bluetooth Feature：

1、CMOS single-chip fully-integrated radio and baseband。

2、Compliant with Bluetooth V5.0+BR+EDR specification。

3、Bluetooth Piconet and Scatternet support。

4、Meet class2 and class3 transmitting power requirement。

5、Support GFSK and π/4 DQPSK all paket types。

6、Provides 4±1dBm EIRP transmitting power。

7、receiver with -89dBm sensitivity。

8、Support a2dp\avctp\avdtp\avrcp\hfp\spp\smp\att\gap\gatt\rfcomm\sdp\l2cap profile。

Summary of content (5 pages)

PAGE 1
PWBT-FDBT OWNER’S MANUAL Bluetooth Feature： 1、CMOS single-chip fully-integrated radio and baseband。 2、Compliant with Bluetooth V5.0+BR+EDR specification。 3、Bluetooth Piconet and Scatternet support。 4、Meet class2 and class3 transmitting power requirement。 5、Support GFSK and π/4 DQPSK all paket types。 6、Provides 4±1dBm EIRP transmitting power。 7、receiver with -89dBm sensitivity。 8、Support a2dp\avctp\avdtp\avrcp\hfp\spp\smp\att\gap\gatt\rfcomm\sdp\l2cap profile。
PAGE 2
High performance 32-bit RISC CPU RISC 32-bit CPU DC-160MHz operation Support DSP instructions 64Vectored interrupts 4 Levels interrupt priority Power Supply DC 3.3V Loading current 150mA Temperature Operating temperature: -20℃ to +70℃ Storage temperature: -65℃ to +150℃ FCC & IC application: This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s).
PAGE 3
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
PAGE 4
The requirement for KDB 996369 D03: 1 List of applicable FCC rules FCC Part 15. 247. 2 Summarize the specific operational use conditions None 3 Limited module procedures The module is a single module, so this requirement is not applicable to the product. 4 Trace antenna designs The module uses the permanent PCB antenna, so this requirement is not applicable to the product.
PAGE 5
The host device manufacturer can use the module directly without RF exposure consideration for the module satisfies SAR at 5mm. 6 Antennas For Bluetooth: PCB antenna, 0.5dBi max 7 Label and compliance information If this certified module is installed inside the host device, then the outside of the host must be labeled with “Contains FCC ID: 2ABXEHSE2012A and IC: 11809A-HSE2012A”. 8 Information on test modes and additional testing requirements The host manufacturer can use the software FCCAssist 2.