User Manual

/03
Pair the lock with APP
Install latch/deadbolt and cylinder
Please install under the guidance of a professional
In case of special circumstances, Please handle with care to avoid damage!
●
●
Screw
Screw
Direction
Unlock key
Reset button
Delete/exit key
Adjust the lock before installation
Pull out the cables from the front and back panel,
and connect them as shown in the figure
Installation notes
If your door lock hole, panel mounting holes and the lock do not match, please refer the illustration
(drilling hole) and adjust the hole. Non-professionals shall not drill holes to avoid causing damage!
Warning
/04
After power is on, while the front panel touchscreen
backlight is off:
1. Tap the touch screen to activate
2. Open the app after voice prompt "please add
bluetooth administrator"
3. Tap profile picture on the top left corner, select "add
lock"-"door lock"
4. Select the lock device name that is found. After adding
successfully, the page will jump to the lock list. If not
successful, repeat the above steps or long press the reset
button in the back panel until you hear the voice prompt
Important
Pair with App using bluetooth
Front panel
Back panel