User Manual

Installation steps:
Lock body: Fix the lock body (figure 1) with two screws
(figure 2)
Front panel: Fix the rubber pad on front panel and press it
on the door (figure 3). Pull the power cable through the
holes in the door (figure 4) , the iron plae (figure 5) and fix
the iron plate with screws.
Back panel: Connect the back panel with the power cable
(figure 6), adjust the position of back panel and press it on
the iron plate, make sure the spindle goes across the circular
hole in the iron plate and into the lock body (figure 7). Fix
the back panel with screws (figure 8 and figure 9).
Install front/back panel
Bolt switch test
Turn the bolt switch, if
the bolt come out and
retract properly, fix the
back panel with a
screw.
Screw
/06/05
1
3
5
8
9
4
2
Back panel
6
7
Front panel