Data Sheet

8 Appendix: Statement

FCC Caution: Any changes or modi󰍓cations not expressly approved by the party

responsible for compliance could void the user’s authority to operate this device.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

Note: This device has been tested and found to comply with the limits for a Class

B digital device, according to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential instal-

lation. This device generates, uses, and can radiate radio frequency energy and, if

not installed and used following the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation.

If this device does cause harmful interference to radio or television reception, which

can be determined by turning the device o󰍒 and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the device and receiver.

• Connect the device into an outlet on a circuit di󰍒erent from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement

This device complies with FCC radiation exposure limits set forth for an uncontrolled

rolled environment. This device should be installed and operated with a minimum

distance of 20cm between the radiator and your body.

Important Note

This radio module must not be installed to co-locate and operate simultaneously

with other radios in the host system except following FCC multi-transmitter product

procedures. Additional testing and device authorization may be required to operate

simultaneously with other radios.

The availability of some speci󰍓c channels and/or operational frequency bands are

country dependent and are 󰍓rmware programmed at the factory to match the in-

tended destination. The 󰍓rmware setting is not accessible by the end-user.

30 / 32