Product Manual

BT3L Datasheet
19
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20
cm between the radiator and your body.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
The availability of some specific channels and/or operational frequency bands is country
dependent and firmware programmed at the factory to match the intended destination.
The firmware setting is not accessible by the end user.
The final end product must be labeled in a visible area with the following:
"Contains Transmitter Module 2ANDL-BT3L"
This radio module must not be installed to co-locate and operating simultaneously with
other radios in host system, additional testing and equipment authorization may be
required to operating simultaneously with other radio.