Data Sheet

8 APPENDIX-STATEMENT
rolled environment. This device should be installed and operated with a minimum
distance of 20cm between the radiator and your body.
Important Note
This radio module must not be installed to co-locate and operating simultaneously
with other radios in the host system except following FCC multi-transmitter product
procedures. Additional testing and device authorization may be required to operate
simultaneously with other radios.
The availability of some specific channels and/or operational frequency bands are
country-dependent and are firmware programmed at the factory to match the in-
tended destination. The firmware setting is not accessible by the end-user.
The host product manufacturer is responsible for compliance with any other FCC
rules that apply to the host not covered by the modular transmitter grant of certi-
fication. The final host product still requires Part 15 Subpart B compliance testing
with the modular transmitter installed.
The end-user manual shall include all required regulatory information/warnings as
shown in this manual, including “This product must be installed and operated with
a minimum distance of 20 cm between the radiator and user body”.
This device has got an FCC ID: 2ANDL-CB3S. The end product must be labelled
in a visible area with the following: “Contains Transmitter Module FCC ID: 2ANDL-
CB3S”.
This device is intended only for OEM integrators under the following conditions:
The antenna must be installed such that 20cm is maintained between the antenna
and users, and the transmitter module may not be co-located with any other trans-
mitter or antenna.
As long as the 2 conditions above are met, further transmitter tests will not be re-
quired. However, the OEM integrator is still responsible for testing their end-product
for any additional compliance requirements required with this module installed.
Declaration of Conformity European Notice
Hereby, Hangzhou Tuya Information Technology Co., Ltd declares that this module
product complies with essential requirements and other relevant provisions of Direc-
26 / 27