Data Sheet

7 Appendix: Statement

FCC Caution: Any changes or modi󰍓cations not expressly approved by the party

responsible for compliance could void the user’s authority to operate this equip-

ment.The module is limited to installation in mobile or fixed applications.

This device complies with Part 15 of the FCC Rules.Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a

Class B digital device, according to part 15 of the FCC Rules.These limits are

designed to provide reasonable protection against harmful interfer-ence in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used by the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment o󰍒 and on, the user is encouraged to try to correct the inter-

ference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit di󰍒erent from that to which

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncon-

trolled environment. This equipment should be installed and operated with a mini-

mum distance of 20cm between the radiator and your body.

Important Note

This radio module must not be installed to co-locate and operating simultaneously

with other radios in the host system except in accordance with FCC multi-

transmitter product procedures. Additional testing and equipment authorization

may be re- quired to operate simultaneously with other radios.

The availability of some specific channels and/or operational frequency bands are

country dependent and are firmware programmed at the factory to match the

intended destination. The firmware setting is not accessible by the end-user.

19 / 22