Data Sheet

7 Appendix: Statement
country dependent and are 󰍓rmware programmed at the factory to match the in-
tended destination. The 󰍓rmware setting is not accessible by the end-user.
The host product manufacturer is responsible for compliance with any other FCC rule
that applies to the host not covered by the modular transmitter grant of certi󰍓cation.
The 󰍓nal host product still requires Part 15 Subpart B compliance testing with the
modular transmitter installed.
The end-user manual shall include all required regulatory information/warnings as
shown in this manual, including “This product must be installed and operated with
a minimum distance of 20 cm between the radiator and user body.”
This device has got an FCC ID: 2ANDL-ZS4S-IPEX. The end product must be labeled
in a visible area with the following: “Contains Transmitter Module FCC ID: 2ANDL-
ZS4S-IPEX”.
This device is intended only for OEM integrators under the following conditions: The
antenna must be installed such that 20cm is maintained between the antenna and
users, and 2) The transmitter module may not be co-located with any other trans-
mitter or antenna. As long as the 2 conditions above are met, further transmitter
tests will not be required. However, the OEM integrator is still responsible for test-
ing their end-product for any additional compliance requirements required with this
module installed.
Declaration of Conformity European Notice
Hereby, Hangzhou Tuya Information Technology Co., Ltd declares that this module
product is in compliance with essential requirements and other relevant provisions
of Directive 2014/53/EU,2011/65/EU. A copy of the Declaration of conformity can be
found at https://www.tuya.com.
23 / 24