User's Manual

48 Starting Installation
Dismantling and Replacement of KAT WALK VR
Omni-directional Treadmill
Dismantling the Shell
1. Unscrew all the bolts on the metal plate at the bottom of the support pillar to separate the plate.
2. Unscrew all the bolts on the metal plate at the girder tail to separate the plate.
Dismantling of Mechanical and Electrical Structure
1. Plug out all the DC cables connected to the power socket.
2. Turn the base plate holder and move the KAT WALK to a flat and open field.
3. Unscrew the bolt on the installation panel of the connecting rod to dismantle the rod.
4. Dismantle the metal plate shells of the KAT WALK one by one.
5. Turn the fixing bolt at the bottom of the support pillar, with one person holding the pillar at its back to prevent it from
toppling suddenly.
6. Put the support pillar down backwards so that it lies flat on the floor. Place a foam pad of at least 20cm thickness
down the pillar in advance.
7. Pull out the three-in-one data cable of the head-mounted display on the telescopic stick from the girder, extract the
data cable part in the telescopic stick, and take the three-in-one data cable out of the head-mounted display.
8. Unscrew the fixing bolt on the flange between the support pillar and the girder and turn the girder so that it is parallel
to the floor.
9. Turn the flange between the support pillar and the girder to separate them.
10. Unscrew the bolt between the support pillar and the base plate and turn the hinges to separate the pillar and the
plate.
Safety Reminder
For safety purpose, please make sure all the power sources are off before the dismantling.