Owner's Manual

21
03. Waist sensor mag calibration: When used for the first time,
the waist sensor requires to collect the location data to complete
the calibration process. Select 'Waist Mag Calibration' in KAT
Gateway and follow the instructions on the screen.
In order to start the calibration process,select 'Waist Mag Calibra-
tion' in KAT Gateway and follow the instructions on the screen.
L Signal Light R Signal Light
Note: I Mag calibration should be carried out at the actual location of use.
II If you change your location, please re-calibrate the device.
04. Putting on the Ankle sensors:
I. Before putting the sensors onto your ankles you have to install
the velcro straps on them. First, make sure that the loop side faces
the outside, and then thread the velcro straps through the buckles
at the backside of the sensors (Make sure you thread the entire
strap till its end. Otherwise, improper placement of the sensor on
your leg might influence the operation of the device).