Safety Instructions

FLOAT CONVERSION:
1. Remove the wing from the fuselage.
2. Remove the wheels from the main landing
gear.
3. Remove the tail wheel and tail wheel wire
from the fuselage.
4. Attach the rear main gear onto the bottom of
the airplane using two flat straps and (4)M3x8
screws. Make sure the wire angles to the
back.
5. Insert the two float spreader bars into the
inside holes of the float and secure with
(4)M3x8 screws.
6. Attach the floats to the main gear.
7. Make sure the floats are lined up straight with
the fuselage. When satisfied, secure the main
gear to the floats using (4)M3x8 screws.
8. Attach the water rudder to the rudder.
Tighten the (1)M3x6 screw to secure it in
place.