User's Manual

Ⅳ. Inclusion to Z-Wave network
The sensor can be added to the Z-Wave network by following steps:
（1）Power on the device by USB or batteries.
（2）Set z-Wave gateway/hub to learning mode (see Z-Wave gateway/hub Operation
Manual)
（3）Triple click the device's Z-Wave button
（4）The LED indicator of the sensor will keep flashing quickly. If the inclusion is successfully
connected, the LED light will be off. Otherwise, after a timeout of 30 seconds, it will be flash
ing slowly (enter the SmartStart function) and please repeat the operation of step (2) to
include to the network.
Tips:
If you want the multi- sensor to be a secure device that can communicate on
a Z-Wave network using secure/encrypted messages, then enabling a secure
Z-Wave controller is necessary
!