User's Manual
V. Exclusion from Z-Wave network
The sensor can be excluded from the Z-Wave network by following steps:
(1)Power on the device
(2)Set z-Wave gateway/hub to exclusion mode (see Z-Wave gateway/hub Operation
Manual)
(3)Triple click the device's Z-Wave button
(4)The LED indicator of the sensor will keep flashing quickly. If the exclusion is succeeded,
the LED light will be flashing slowly (enter the SmartStart function). Otherwise, after a
timeout of 30 seconds, it will be off and please repeat the operation of step (2) to include to
the network.
Ⅵ. RESET THE DEVICE
Reset procedure clears the Multisensor’s memory, including Z-Wave network controller
information. To reset the Multisensor:
(1)Power on the device,
(2)press and hold the Z button for more than 20 seconds
(3)If holding time more than 20 seconds, the LED indicator will keep on for 2 seconds,
which means resetting is complete.
(4)The reset feature works only when the device has been included into a Z-Wave
network.
Note:
Use this procedure only in the event that the network primary controller
is missing or otherwise inoperable.
Ⅶ. ASSOCIATIONS
Association allows Multisensor to control other Z-Wave device such us Smart Switch,
dimmer,etc.
Multisensor supports two association groups.
Multisensor can max associate 5 nodes in each group.
Group 1 reports the conditions of the Multisensor, battery level, temperature, humidity,
luminance and motion detection.
Group 2 is assigned to the Multisensor sends BASIC SET command.
!