User's Manual

2. This Sensor should only be placed indoor and away from water and other extreme
weather conditions.
7.2 Using one of the following methods to mount the device to the wall, door or window:
 3M Tap Mode
1) Stick the included self-adhesive pads to the bottom of the device and magnet.
2) Peel off the protective layer of the sticker.
3) Stick the device onto the door/window frame.
4) Stick the magnet onto the moving part of the door/window, no further than 10mm from the sensor
NOTE:
Wipe clean the surface where the Door Window Sensor will be mounted.
Any dust and particles can reduce the adhesion of double-sided mounting tape.
 Screw Mode
1) Take the battery cover apart from the device part by pressing and holding the latch button and the
holder of the magnet part;
2) Screw the battery cover on to the door or window frame;
3) Keep the orientation marks of the device part and the magnet are oriented towards each other;
4) Screw the magnet holder to the moving part of the door or window;
5) Mount the device part on to battery cover;
6) Mount the magnet part to the holder.
!