User Manual

ConnectSense® Router Rebooter
with EZ Setup/Use Technology
630-245-1445 CONNECTSENSE.COM
CONNECTSENSE, A DIVISION OF GRID CONNECT INC. | 1630 W. DIEHL ROAD, NAPERVILLE, IL 60563
CSRR93020
Specifications
Wi-Fi IEEE 802.11 b/g/n Wi-Fi 2.4Ghz
Input power 90-135VAC
Output power 120VAC, 15A Max
Inrush current 30A
Standby Power <1Watt
Frequency 60Hz
Over Current Protection 30A
Operating Temperature -10 to +40 degC
Storage Temperature -20 to +60 degC
Relative Humidly 8 to 80% non-condensing
Certifications ETL certified to UL standard
FCC certified
Color White
Size 500mm(L) x 65mm(W) x 27mm(H)
Part Number CS-MINI-CORD-REBOOTER
FCC Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated
with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
FCC ID: 2AXIE-SW02WU