User's Manual

9. RESET DEVICE

Reset the humidity & temperature sensor from the network:

1) Login the APP and click the device

2) Click the icon in the upper right corner of the device and click "Remove Device"

3) Click "Disconnect and wipe data" and click "confirm" in the pop-up box;

4) After the device is successfully reset, the device will be disappeared from the APP interface

and enter configuration mode

Note:

“Disconnect and wipe Data” will clear the memory of the temperature and

humidity sensor, it means delete all information about the wireless network

and configuration.

10. FCC NOTICE (for USA)

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference

(2) This device must accept any interference received, including interference that may cause

undesired operation.

The manufacturer is not responsible for any radio or tv interference caused by unauthorized

modifications or change to this equipment. Such modifications or change

could void the user’s

authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is