User Guide

Instruction Manual
C9800
REACTOR
www.hannainst.com
This Instrument is in
Compliance with the CE Directives
Dear Customer,
Thank you for choosing a Hanna product. Please read this
instruction manual carefully before using the reactor. This
manual will provide you with the necessary information for
the correct use of the heater. If you need additional
technical information, do not hesitate to e-mail us at
[e-mail]. These instruments are in compliance
with
directives.
Hanna Instruments reserves the right to modify the design, construction
and appearance of its products without advance notice.
WARRANTYWARRANTY
WARRANTYWARRANTY
WARRANTY
C9800 is warranted for two years against defects in workmanship
and materials when used for its intended purpose and maintained
according to instructions.
This warranty is limited to repair or replacement free of charge.
Damages due to accident, misuse, tampering or lack of prescribed
maintenance are not covered.
If service is required, contact the dealer from whom you purchased the
instrument. If under warranty, report the model number, date of pur-
chase, serial number and the nature of the failure. If the repair is not
covered by the warranty, you will be notified of the charges incurred. If
the instrument is to be returned to Hanna Instruments, first obtain a
Returned Goods Authorization Number from the Customer Service de-
partment and then send it with shipment costs prepaid. When shipping
any instrument, make sure it is properly packaged for complete protec-
tion.
To validate your warranty, fill out and return the enclosed warranty card
within 14 days from the date of purchase.
All rights are reserved. Reproduction in whole or in part is prohibited
without the written consent of the copyright owner, Hanna Instru-
ments Inc., Woonsocket, Rhode Island, 02895 , USA.
Remove the instrument from the packing material and
examine it carefully to make sure that no damage has
occurred during shipment. If there is any damage, notify
your Dealer.
Note: Save all packing material until you are sure that
the instrument functions correctly. Any defective item
must be returned in their original packing with the
supplied accessories.
Before unpacking, setting up or start using this reactor it is
important to read carefully this manual. Pay particular
attention to all warnings, cautions and notes. Failure to do
so could result in serious injury to the operator or damage
to the equipment.
To ensure a safety use of this instrument, it must not be
installed or used in any manner other than that specified
in this manual.
Reactor Operation: The Reactor incubates glass
vials containing hazardous chemicals at high tem-
perature. Read the Health & Safety Data Sheet
(HSDS) before handling reagent vials.
Handling Reagent Vials: Handle the vials very carefully
and wear protective clothing. After use, dispose of the
reagent vials according to local regulations.
Safety Equipment: When operating with Reactor use
protective clothing, including goggles or face mask, and
gloves.
Use of the optional safety shield is highly recommended.
Reagent Spills: Wipe up spilled reagents immediately. If
reagent contacts skin, rinse the affected area thoroughly
with water. Avoid breathing released vapors. Read the
Health & Safety Data Sheet (HSDS) of each reagent for
complete chemical information.
Fire Hazard: Avoid the presence of flammable liquids or
paper near the operating Reactor. A fire hazard could be
created.
HEALTH & SAFETYHEALTH & SAFETY
HEALTH & SAFETYHEALTH & SAFETY
HEALTH & SAFETY
C9800 Reactor is a Hanna Instruments thermo-reactor
with a metal dry-block and a metal case construction.
It allows to warm up to 25 samples, contained into 16
mm-diameter tubes, at 105 or 150 ºC.
The reactor is equipped with led indicators, to inform when
power is on and heating is operating, and a 120 minutes
timer, very useful in timed digestion procedures.
It is possible to select time intervals between 0 and 120
minutes and, during these intervals, temperature in the
heater is maintained constant. At the end of the selected
interval an acoustic alarm will sound and the heater will
automatically shut off.
The reactor is also provided with a thermal fuse that
prevents from overheating, by shutting down the heater.
Two models are available:
C9800-01 runs with 115 VAC mains line
C9800-02 runs with 230 VAC mains line.
GENERAL DESCRIPTIONGENERAL DESCRIPTION
GENERAL DESCRIPTIONGENERAL DESCRIPTION
GENERAL DESCRIPTION
SPECIFICATIONSSPECIFICATIONS
SPECIFICATIONSSPECIFICATIONS
SPECIFICATIONS
Capacity 25 16x100 mm vials and
1 receptacle for a stainless steel probe thermometer
Temperature selectable, 105 or 150 ºC
Accuracy ±2 ºC @ 25 ºC ambient
Temperature stability ±0.5 ºC
Warm-up time 30-40 minutes,
depending on set temperature
Timer 0-120 minutes with acoustic alarm
and automatic shut-off,
or infinity mode feature
Ambient operating temperature +5 to +50 ºC
Storage temperature -20 to +60 ºC
Power supply:
C9800-01 115 VAC; 60Hz; 250W; Fuse 4A
C9800-02 230 VAC; 50Hz; 250W; Fuse 2A
Dimensions 190 x 300 x 95 mm (7.5 x 11.8 x 3.9’’)
Weight approx. 4.8 kg (10.6 lb.)
PRELIMINARY EXAMINATIONPRELIMINARY EXAMINATION
PRELIMINARY EXAMINATIONPRELIMINARY EXAMINATION
PRELIMINARY EXAMINATION