Owner manual

PC INTERFACEPC INTERFACE

PC INTERFACE

Data transmission from the instrument to the PC can be done with the

HI 92000 Windows

compatible software (optional). HI 92000 also

offers graphing and on-line help feature.

Data can be exported to the most popular spreadsheet programs for

further analysis.

To connect your instrument to a PC, use a standard USB cable connector.

Make sure that your instrument is switched off and plug one connector to

the instrument USB socket and the other to the USB port of your PC.

Note: If you are not using Hanna Instruments HI 92000 software,

please see the following instructions.

SENDING COMMANDS FROM PC

It is also possible to remotely control the instrument with any terminal

program. Use a standard USB cable to connect the instrument to a PC,

start the terminal program and set the communication options as follows:

8, N, 1, no flow control, 9600 baud rate.

COMMAND TYPES

To send a command to the instrument follow the next scheme:

<command prefix> <command

<CR>

where: <command prefix> is a 16 ASCII character

<command> is the command code.

Note: Either small or capital letters can be used.

SIMPLE COMMANDS

RNG Is equivalent to pressing RANGE

CAL Is equivalent to pressing CAL

CFM Is equivalent to pressing CFM

UPC Is equivalent to pressing the UP arrow key

DWC Is equivalent to pressing the DOWN arrow key

LOG Is equivalent to pressing LOG

RCL Is equivalent to pressing RCL

SET Is equivalent to pressing SETUP

CHR xx Change the instrument range according with the parameter

value (xx):

• xx=01 pH range/0.01 resolution

• xx=02 mV range