Thermometer User Manual

DISPLAYING MODESDISPLAYING MODES

DISPLAYING MODES

For each measurement mode (pH, mV, Rel mV or Ion) the following display configurations are available:

Basic, Good Laboratory Practice (GLP), Graph and Log History.

Basic

Accessing this option, the measured value and its units are displayed on the LCD, along with the temperature

value, temperature compensation mode, and GLP data.

To choose the Basic displaying mode:

• Press

while in

Measure

mode. The “Choose Display Configuration” message will be displayed in

the Reminder messages area.

• Press

. The instrument will display the basic information for the selected measurement mode.

GLP

Accessing this option, detailed GLP data will be displayed on the LCD for

pH Measure

and

ISE Measure

modes

only: Last Calibration date and time, Offset and Slope values, Calibration Buffers/Standards and general

information regarding the buffers/standards: the calibration temperature, temperature compensation mode,

date and time. For

pH Measure

, the Electrode Condition is also displayed on the LCD in percent.

Note: If only a one-point pH calibration is performed or the current calibration does not include at least two consecutive

standard buffers of pH 4.01, 7.01 (6.86) and 10.01 (9.18) buffers, the Electrode Condition will be unknown.

To access the GLP displaying mode:

• Press

while in

Measure

mode. The “Choose Display Configuration” message will be displayed in

the Reminder messages area.

• Press . The instrument will display the detailed GLP data.