User Guide

ManualsBrandsHanna Instruments ManualsOtherHI 9050

BATTERY

The instrument stops operating when the low

battery signal is detected. The user is warned

of this by the code "Eb".

Battery replacement should only take place

in a non-hazardous area using an alka-

line 9V battery.

Remove the battery cover at the rear of

the meter and replace the 9V battery with

a new one. Press in the battery contacts to

make sure they are properly inserted be-

fore replacing the cover.

BATTERY REPLACEMENTBATTERY REPLACEMENT

BATTERY REPLACEMENT

Hanna Instruments offers a wide range of probes to meet all your

requirements from liquids to air and penetration. These probes use

highly sensitive thermistor sensors which provide greater accuracy,

faster response and a temperature range that is superior to conven-

tional thermistor probes.

All Hanna temperature probes are supplied pre-calibrated from the

factory and are ready to be used with your meter. The probes are

easily to your meter with a standard connector.

Completely interchangeable, these probes make it possible for you to

switch from one to another without wasting time and money going

through time-consuming and tedious calibration procedures.

The probes are available in different colors to avoid cross contamina-

tion during testing:

HI 765A Air probe, with 1 m (3.3') cable and white handle

HI 765A/10 Air probe, with 10 m (33') cable and white handle

HI 765BL General purpose liquid probe, with 1 m (3.3') cable

and black handle

HI 765BL/10 General purpose liquid probe, with 10 m (33') cable

and black handle

HI 765L General purpose liquid probe, with 1 m (3.3') cable

and white handle

HI 765L/10 General purpose liquid probe, with 10 m (33') cable

and white handle

HI 765PBL Penetration probe with 1 m (3.3') cable and blue

handle

TEMPERATURETEMPERATURE

TEMPERATURE

PROBES & ACCESSORIESPROBES & ACCESSORIES

PROBES & ACCESSORIES

Untitled-5

HI 765PBL/10 Penetration probe with 10 m (33') cable and blue

handle

HI 765PG Penetration probe with 1 m (3.3') cable and green

handle

HI 765PG/10 Penetration probe with 10 m (33') cable and green

handle

HI 765PR Penetration probe with 1 m (3.3') cable and red

handle

HI 765PR/10 Penetration probe with 10 m (33') cable and red

handle

HI 765PW Penetration probe with 1 m 3.3') cable and white

handle

HI 765PW/10 Penetration probe with 10 m (33') cable and white

handle

HI 765W Wire probe, without handle (hard-to-reach places)

with 1 m cable

HI 765W/10 Wire probe, without handle (hard-to-reach places)

with 10 m cable

HANNA INSTRUMENTS TEMPERATURE PROBES