Microphone User Manual

4 cm

(1½

°C

• In HI8417 the temperature reading is also displayed on the left

LCD.

Note: the electrode should be submerged approximately 4 cm (1½")

into the solution. If the temperature probe is used, it should

be located as close to the pH electrode as possible.

If measurements are taken in different samples successively, it is

recommended that the electrode is rinsed thoroughly for better condi-

tioning and to eliminate cross-contamination of the sample.

For the rinsing process, it is recommended to use a liberal amount of

the next solution to be measured.

Using refillable electrodes

Unscrew the small refill cap to open the refill hole during measure-

ments. After measurement replace the refill hole cap.

MANUAL TEMPERATURE COMPENSATION FOR HI8417,

HI8520 AND HI8521

• When the temperature probe is not connected,

take the temperature of the solution with a

ChecktempC or a glass thermometer.

• Press the RANGE key to enter the temperature mode

(not necessary for HI8417).

RANGE

°C