User Manual

FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
- 2 -
LOCATION OF CONTROLS
1. Carry Handle 16. CD FOLDER UP Button
2. CD Compartment 17. CD SKIP/SEARCH Button
3. BAND Switch 18. CD
Button
4. TUNING Knob 19. CD Button
5. FUNCTION Switch 20. CD MODE Button
6. Dial Scale 21 LCD Display
7. Cassette STOP Button 22. POWER Indicator
8. Cassette F.F. Button 23. FM ST. Indicator
9. Cassette REW Button 24. Cassette Compartment
10. Cassette EJECT Button 25. Speaker
11. Cassette PLAY Button 26. Rod Antenna
12. Cassette REC Button 27. Headphone Jack
13. VOLUME Control Knob 28. Battery Compartment
14. CD Door OPEN Button 29. AC Socket
15. CD SKIP/SEARCH Button
CONNECTING THE UNIT TO POWER
AC OPERATION
Before operation, please make sure that the VOLTAGE mentioned on the unit is same as the
voltage of your local area. Unravel the AC power cord, insert one end into the AC socket on the set,
and the other end into a standard AC outlet.
- 3 -