Use and Care Manual

ManualsBrandsHanover ManualsFire PitsAspen Creek 19 in. Aluminum High-Top Fire Pit Table in Dark Oak



HanoverOutdoorFurniture



IMPORTANT

Ifyouhaveanyproblemswiththisproduct(missingordamagedparts,assemblyissues,etc.),

PLEASEDONOTRETURNTOTHERETAILER/STORE

fromwhereyoupurchasedtheproduct.

PleasecallourToll‐FreeCustomerServiceHotlineat:

1‐800‐416‐3511

Between9:00AMand5:00PMEasternTime,MondaythroughFriday

Orvisitourwebsiteat:

www.hanover‐products.com



Toexpediteanyfuturewarrantyclaims,pleaseretaintheInstructionSheet,Warranty

Cardandreceiptforfutureuse.



Foradditionalon‐linesupportonassembly,troubleshootingandcare&maintenanceofyouroutdoor

furniture,pleasevisitourwebsiteat:www.hanover‐products.com. 

6/1/2015(a)

Summary of content (11 pages)

PAGE 1
Hanover Outdoor Furniture IMPORTANT If you have any problems with this product (missing or damaged parts, assembly issues, etc.), PLEASE DO NOT RETURN TO THE RETAILER/STORE from where you purchased the product. Please call our Toll‐Free Customer Service Hotline at: 1‐800‐416‐3511 Between 9:00 AM and 5:00 PM Eastern Time, Monday through Friday Or visit our website at: www.hanover‐products.
PAGE 2
ASSEMBLY INSTRUCTIONS CSA Model 98900 DRS03500 Installer: Leave these instructions with consumer. Consumer: Keep these instructions for future reference. DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, keep away from the appliance and immediately call your gas supplier or fire department. WARNING: Improper installation, adjustment alteration, service or maintenance can cause injury or property damage.
PAGE 3
IMPORTANT SAFETY INFORMATION The installation must conform with local codes or, in the absence of local co des, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54; International Fuel Gas Code. ; Natural Gas and Propane Installation Code, CSA B149.1; or Propane Storage and Handling Code, B149.2, as applicable. The ap pliance and it s appliance main gas valve must be disconnected from the gas supply pipi ng system during an y p ressure test ing of that system at test pressures in excess of 1/2 psi (3.5kPa).
PAGE 4
IMPORTANT SAFETY INFORMATION ABOUT PROPANE (LP) GAS A self cont ained LP-gas cylinder for use w ith this appliance must have a capacity of 20 lbs/9 kgs. and must be equipped with a Type 1 connector and an OPD (overfill protection device). See Figure 1. The LP-gas supply c ylinder to be used m ust be constructed and marked in accordance with the specific ation for LP-gas cylinders of the U.S.
PAGE 5
PARTS IDENTIFICATION LIST PART DESCRIPTION PART# A LAZY SUSAN/BURNER COVER FP0777 1 B GAS VALVE FP0307 1 C THERMOCOUPLE FP0004 1 D LP REGULATOR HOSE FP0308 1 E ELECTRODE FP0003 1 F ORIFICE ELBOW FP0310 1 G IGNITION MODULE FP0006 1 H ORIFICE BRACKET FP0311 1 I PROPANE ORIFICE FP0312 1 J NATURAL GAS ORIFICE FP0313 1 K “AAA” BATTERY(1.
PAGE 6
INSTALLATION 1.Identify parts packed in carton against the parts list. Remove all protective materials and set parts on a flat, non-abrasive surface. There must be a minimum of 24 inches of clearance from the side of the tabletop to any combustible walls 2.Place the tabletop upside-down on a flat, non-abrasive surface. Insert four 1/4"x40 mm headless bolts (N) into the pre-drilled hole on the underside of the tabletop as shown in Fig. 3. Do not over tighten. Figure 3 3.
PAGE 7
4.Attach the upper frame (T) to completed bottom frame by using six 1/4"x30 mm bolts (P) and washers (Q) as shown in Figure.5. Guide bolts through holes in upper frame, into pre-drilled hole in the bottom frame. Hand-tighten only. Figure 5 5.With the help of another person, turn the table base assembly in the upright position. Also with the help of another person, carefully place the tabletop onto the table base.
PAGE 8
7. Pour the fire ice into the burner pan completely covering the burner. See Figure 7. BURNER PAN Figure 7 IGNITION WELL 8. Remove the cardboard cover from the ignition well as shown in Figure 8. Remove any lava rock or fire ice on top of ignition well. CARDBOARD COVER Figure 8 9. Slide the tank drawer out and place the LP tank in the drawer. Connect the regulator as shown in Figure 9. Turn the black handle clock-wise to tighten. Turn the Handle counter clock-wise to remove. The hose must point down.
PAGE 9
NATURAL GAS CONVERSION Natural gas conversion must be performed only by your natural gas provider or service company. 1. Disconnect the regulator hose from the gas valve. See Figure 11. Figure 11 2. Disconnect the gas tube from the orifice elbow. Remove the two M4 nuts and remove the orifice older. Replace the propane orifice with the natural gas orifice from the kit and reinstall the orifice holder. Apply a solution of soapy water to all connections to check for leaks.
PAGE 10
BATTERIES Make sure the control knob is in the "OFF" position. Unscrew the push button cap on the ignition module located on the control panel to access the battery compartment. The ignition module requires one Alkaline AAA size battery (1.5V). The negative (-) end goes in first. See Figure 13.Dispose of battery safely. May explode or leak if charged or disposed of in fire. Make sure of the polarity. Mercury and cadmium free.
PAGE 11
4. To shut down the fire pit, turn the control knob to the “OFF” position and turn off the tank valve. MAINTENANCE The flames should look like those in Figure 15. To clean the burner, use a soft brush after the burner has cooled completely. Never use a vacuum cleaner on the burner. It is recommended that the fire pit be stored indoors during the winter if it will be subjected to freezing temperatures.