Page 2 of 7
High Dining Table Owner's Manual If you have any problems with this product, DO NOT RETURN IT TO THE STORE CALL OUR CUSTOMER SERVICE HOT-LINE AT 1-866-851-8438 Between 9 A.M. - 5 P.M.
Page 3 of 7
Page 4 of 7
PARTS LIST PART# DESCRIPTION A Table top 1 B Table leg 4 C Support Tube 8 D Connector 1 AA M6 x15mm 4 BB Bolt M6 x18mm 16 CC Bolt M6 x 35mm 16 DD Washer 36 EE Bolt Cover 36 FF Wrench 1 Page 5 of 7 PICTURE QTY
Assembly Steps: Note: Do not fully tighten bolts until assembly is completed and alignment is correct. Step 1. Assemble the connector (D) to the table leg (B) with bolts (AA) and washer (DD) as shown in figure 1. Figure 1 Step 2. Carefully place the table top (A) upside down on a non-abrasive surface. Step 3. Assemble the table legs (B) to the table top (A) with bolts (BB) and washer (DD) as shown in figure 2.
Step 4. Loosely attach the support tube (C) to the table leg (B) and table top (A) with bolts (CC) and washer (DD) as shown in figure 3. Step 5. Check the alignment and adjust if necessary. Once the alignment is correct, tighten all bolts with wrench (FF) . Cover all bolts with bolt caps(EE). Figure 3 Step 6. Verify all bolts are securely tightened before use and turn your table right side up. Your table is now ready to use. (Figure 4).
High Dining Swivel Chair Owner's Manual If you have any problems with this product, DO NOT RETURN IT TO THE STORE CALL OUR CUSTOMER SERVICE HOT-LINE AT 1-866-851-8438 Between 9 A.M. - 5 P.M.
PARTS LIST PART# DESCRIPTION A Chair Frame 1 B T Rocker 1 C Base 1 D Steel Panel 2 AA Bolt M8 x 45mm 4 BB M8 Washer 8 CC M8 Spring Gasket 4 DD M8 Nut 4 EE M8 Bolt Cover 4 FF Bolt Cover For M8 Nut 4 GG Open Wrench 1 Page 5 of 7 PICTURE QTY
Assembly Steps: Note: Do not fully tighten bolts until assembly is completed and alignment is correct. Step 1. Carefully place the chair frame (A) upside down on a non-abrasive surface. Assemble the T rocker(B) to the chair frame(A) with steel panel(D) and Bolts(AA) and Washer(BB) and M8 Spring gasket (CC) and M8 Nut(DD) by using open wrench(GG), then cover the bolts with bolt covers (EE and FF) as shown in Figure 1. Figure 1 Step 2. Place the chair frame (A) into the base( C ) as shown in Figure 2 .
Step 3. Your chair is now ready to use. (Figure 3).