Instructions / Assembly

FHTS80021D
Sudden drop
or reduced
Irregular
not run the
full length of
the burner
Flame seems
to lose heat
when burning
in cold weather
- temperature
below
50°F (10°C)
Flame is yellow
or orange
Flame
goes out
Flashback
burner tube(s))
Out of gas
have been activated
Ice has built up on the outside
of the LP gas tank because the
New burner may have residual
manufacturing oils
Spider webs or insect nest in
burner/venturi tube
Poor alignment of the valve to
burner/venturi tube
Low on LP gas
Burner and/or burner/venturi
tube is blocked
1. Turn control knob to “OFF”
per “Lighting” section
prevention device:
a. Turn control knob to “OFF”
b. Turn LP gas tank valve to “CLOSED”
c. Disconnect regulator
d. Turn control knob to “ON”
f. Turn control knob to “OFF”
g. Reconnect regulator and leak check
connections, being careful not to fully open valve
1. Turn off per “Turning Off” section
2. Replace with a spare LP gas tank
3. Reconnect LP gas tank per “Installing LP Gas
Tank” section
4. Follow “Checking for Leaks” section
reinspect
Clean burner/venturi tube
Ensure burner/venturi tube is properly engaged
with valve
Clean burner and/or burner/venturi tube
Troubleshooting