Installation and Operation Instructions ELECTRIC FIREPLACE F30WMEF
Important Safety Instructions 4-6 Listing Approvals 7 Product Dimensions 8 Locating Fireplace 9 Unpacking and Testing Fireplace 10 Grounding Instructions 10 Installation Finishing Ckecklist 11-12 Operating Instructions 13-14 Replacing The Rock/Log Set And Light Bulbs 15 Maintenance 16 Troubleshooting 17 13
1. Prior to plugging your heater into an electrical outlet, verify that the house circuit breakers for the outlet are on. 2. The heater may emit a slight, harmless odor when first used. This odor is normal and it is caused by the initial heating of internal heater elements and will not occur again. 3. If your heater does not emit heat, consult the operation section of this manual for further information. 4. Use with a CSA or UL certified surge protector.
IMPORTANT SAFETY INSTRUCTIONS IMPORT ANT INSTRUCTIONS 'Mlen using this electric fireplace, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read all instructions before using this electric fireplace. 2. This heater is hot when in use. To avoid bums, do not let bare skin touch hot surfaces. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from top.
IMPORTANT SAFETY INSTRUCTIONS 11 . Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater. 12. To prevent possible fire, do not block air intakes in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. 13. T he electric fireplace has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored. 14.
X30WMEF 110-120V AC, 60Hz MAX 1400W 30.6 19.2 5.
2 6 5.
3
The manual controls are located on the left side of the fireplace. You have the following controls: 1. Power ON/OFF: Power to the unit 2. Flame brightness controls: Allows you to adjust the flame to suit your mood.Press increase flame brightness and flame brightness.You must press the to to decrease button Several times to see the full flame effect. 3. Low heat:700 watts 4. High heat: 1400 watts Please note: The heater touchpanel control must be touched 2 times to achieve high heat. 5. Heater Timer: 1.
Replacing The Rock/Log Set And Light Bulbs TO CHANGE LOG/ROCK SET (NOTE: MAKE SURE FIREPLACE IS TURNED OFF AND HAS BEEN UNPLUGGED FROM ELECTRICAL OUTLET BEFORE ATTEMPTING TO CHANGE THE LOG/ROCK SET): 1. Place fireplace on a flat, level surface (FIG 1). 2. Remove 3 screws located on each side of glass face of fireplace (FIG 2 and FIG 3). 3. Remove screws that attach the log/rock set to the front of fireplace (FIG 4). 4.
The remote takes 2 x AAA batteries