Instructions / Assembly

Page 4
ASSEMBLY INSTRUCTIONS
COVER
1
Important: We recommend 2 people work together to assemble the chair.
If chair frame has been properly positioned on the rocker assembly, all
arrows on the "U" bar and rocker assembly will be pointing in the same direction.
Note the arrow labels
on the "U" bar and the rocker assembly. Also note the horseshoe shape of the rocker plate. Point the
open end of the horseshoe away from you. The arrows on the rocker assembly should be pointing
towards you. Set the chair frame on the rocker assembly with front of the seat facing you and the
arrows on the "U" bar pointing towards you as shown in . This is very important for a safe,
balanced rocking motion.
Figure 2
Critical Step: The "U" metal plates must be installed in the proper location.
Hand tighten nuts 3-4 revolutions only.
CAUTION: Failure to place "U" metal plates under the rocker plates and above the"U" bar exactly
as shown in the diagram will cause the bolt heads and nuts to damage the structure of the rocker
plates and the "U" bar. Damage due to over tightening of bolts or improper assembly could
cause injury and may void your warranty.
Insert the "U" metal plates, so that the "U" bar and rocker plate are between both
sides of the "U" metal plates. Make sure that the holes in the "U" metal plate are completely aligned
with the holes in the "U" bar as shown in . Guide the bolts through the holes on the top side of
the "U" metal plate, through the holes in the "U" bar, through the holes in the rocker plate and then,
most importantly, through the holes in the bottom side of the "U" metal plate. It is very important that the
holes in the bottom of the "U" metal plate are placed directly beneath the holes in the rocker plate. Add
a spring washer and a nut to each bolt as shown in .
Repeat the same procedure on the other side.
Read this step and
carefully examine.
Figure 3
Figure 3
Tighten all nuts and bolts with the hex wrenches provided. Remove
the arrow labels from the "U" bar and rocker assembly. Cover all bolts with bolt covers.
Bolts must be FULLY tightened.
Figure 3
F
C
D
E
F
"U" BAR
Figure 2
"U" BAR
ROCKER
ASSEMBLY
ROCKER PLATE
G
Assembly detail shown from the REAR of the chair for clarity
CHAIR VIEWED FROM THE FRONT
2
3
B
FOOT CAP
A