Manualshelf

Use and Care Manual

ManualsBrandsHanover ManualsBistro SetsFontana 3-Piece Aluminum Outdoor Bistro Set with 2 Sling Chairs and a 32 in. Cast-Top Table
123456
Page 4
ASSEMBLY INSTRUCTIONS
1
2
Place the table top upside down on a flat, nonabrasive surface. Attach table leg to table top using a 1/4"x18 mm
bolt and washer as shown in the diagram. Guide bolt through hole in table leg, into pre-drilled hole in the table
top. Hand tighten three to four turns only. . Some adjustments may be necessary to
ensure proper alignment of the table legs. Repeat for the other three legs.
Do not tighten completely
3
After making any necessary adjustments to the alignment of the table legs and the leg connector bracket, use the
hex bolt driver to tighten all bolts. each bolt must be tightened a few revolutions at a time. In order to apply
equal pressure to all bolt joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are
tight. . Over tightening may strip bolts. Cover all bolts with covers.
Note:
Do not over tighten
G
E
F
B
C
A
G
D
F
FOOT CAP
Build the leg assembly
Do not tighten tighten completely, only 3-4 turns to ensure the leg stays in position.
. Attach the legs to the leg connector bracket by using the 1/4"x28 mm bolts. Add a washer
to each bolt. Guide these bolts through the holes in the leg connector bracket into the fixed nuts already in place in
the legs. Repeat this
procedure on the other three legs.