Use and Care Manual

OPERATION INSTRUCTIONS

Operation Checklist

Shut Down:

Turn cylinder valve clockwise to OFF and disconnect regulator when heater is not in use.

Note: After use, some discoloration of the emitter screen is normal.

For a safe and pleasurable heating experience, perform this check before each use.

When Heater is ON:

Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner

will display tongues of blue and yellow flame. These flames should not be yellow or produce thick

black smoke, indicating an obstruction of airflow through the burners. The flame should be blue with

straight yellow tops. If excessive yellow flame is detected, turn off heater and consult “Troubleshooting”

on page 18.

Re-lighting:

1. Turn control knob to OFF.

2. Repeat the “Lighting” steps on prior page.

WARNING

FOR YOUR SAFETY

Be careful when attempting to manually ignite this

heater.

WARNING

FOR YOUR SAFETY

Heater will be hot after use. Handle with extreme care.

Before Operating:

1. I am familiar with entire owner’s manual and understand all precautions noted.

2. All components are properly assembled, intact and operable.

3. No alterations have been made.

4. All gas connections are secure and do not leak.

5. Wind velocity is below 10 mph.

6. Unit will operate at reduced efficiency below 40°F.

7. Heater is outdoors (outside any enclosure).

8. There is adequate fresh air ventilation.