Instructions / Assembly

ManualsBrandsHanover ManualsHeatersMini Umbrella Tabletop 11,000 BTU Hammered Bronze Propane Patio Heater

ANS Z83.26-2014 • CSA 2.37-2014 Gas-Fired Outdoor Infrared Patio Heaters

OUTDOOR

PATIO HEATER

User Manual No. 8

Models: 9710203, 9710204

DANGER

If you smell gas:

FOR YOUR SAFETY

1.Shut off gas to the appliance.

2.Extinguish any open flame.

3.If odor continues, keep away from the appliance and

immediately call you gas supplier or fire department.

WARNING

Do not store or use gasoline or other flammable vapors

and liquids in the vicinity of this or any other appliance.

An LP-cylinder not connected for use shall not be

stored in the vicinity of this or any other appliance.

WARNING

Improper installation, adjustment, alteration, service or

maintenance can cause property damage, injury or

death. Read the installation, operation and maintenance

instructions thoroughly before installing or servicing

this equipment.

WARNING: For Outdoor Use Only

DANGER

CARBON MONOXIDE HAZARD

This appliance can produce

carbon monoxide which has

no odor. Using it in an enclosed

space can kill you. Never use this

appliance in an enclosed space

such as a camper, tent, car or home.

Summary of content (15 pages)

PAGE 1
User Manual No. 8 Models: 9710203, 9710204 OUTDOOR PATIO HEATER DANGER FOR YOUR SAFETY If you smell gas: 1.Shut off gas to the appliance. 2.Extinguish any open flame. 3.If odor continues, keep away from the appliance and immediately call you gas supplier or fire department. WARNING Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.
PAGE 2
PACKAGE CONTENTS AA A CC BB FF B G DD FF C D H E F EE PART A B C D E F G H AA BB DESCRIPTION Reflector Emitter Wire Guard Access Panel Base Ring Weight Post with Burner Assembly Heater Housing Castle Nut Reflector Spacer QUANTITY 1 1 1 1 1 1 1 1 3 3 PART CC DD EE FF 2 DESCRIPTION Washer Nut M6 X 20mm Bolt 3/16 in.
PAGE 3
HARDWARE CONTENTS (shown actual size) AA Castle Nuts Qty. 3 CC BB Washers Qty. 6 DD EE Nuts Qty. 3 Reflector spacers Qty. 3 JJ FF M6 X 20 mm Bolts Qty. 4 3/16 in. Stainless Screw Qty. 8 Wrench Qty. 1 (not actual size) SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. This manual contains important information about the assembly, operation and maintenance of this patio heater.
PAGE 4
SAFETY INFORMATION DANGER DANGER • EXPLOSION - FIRE HAZARD • Keep solid combustibles, such as building materials, paper or cardboard, a safe distance away from the heater as recommended by the instructions. • Provide adequate clearances around air openings into the combustion chamber. • Never use the heater in spaces that do or may contain volatile or airborne combustibles, or products such as gasoline, solvents, paint thinner, dust particles or unknown chemicals.
PAGE 5
SAFETY INFORMATION WARNING WARNING California Proposition 65 Combustion by-products produced when using this product contain chemicals known to the State of California to cause cancer, birth defects, and other reproductive harm. • This product is fueled by propane gas. Propane gas is invisible, odorless, and flammable. An odorant is normally added to help detect leaks and can be described as a “rotten egg” smell. The odorant can fade over time so leaking gas is not always detectable by smell alone.
PAGE 6
ASSEMBLY INSTRUCTIONS 1. Attach post with burner assembly (G) onto heater housing (H), using four 3/16 in. Stainless bolts (FF) . Keep the access panel (D) open. 1 G Hardware Used FF FF 3/16 in. Stainless Screw x4 D H 2. Attach ring weight (F) to base (E) , using four M6 X 20 bolts. 2 G Hardware Used H x4 EE M6 X 20 Bolts E F EE 3. Put three reflector spacers (BB) into the holes in the emitter (B). Use three nuts (DD) to hold the reflector spacers inside of the emitter (B).
PAGE 7
ASSEMBLY INSTRUCTIONS 4. Insert ends of wire guard (C) into holes in (G). 4 C G 5. Put 3 washers (CC) into the top of support bolts. Attach reflector to emitter assembly, using 3 nuts (AA) and 3 washers (CC). 5 AA A CC Hardware Used AA Castle Nuts CC Washers x3 x6 6. Rotate regulator toward opening in housing. Line up threads on gas cylinder with those on the regulator. Insert and rotate cylinder clockwise until tight. Close (D).
PAGE 8
ASSEMBLY INSTRUCTIONS 7. Gas Tank Assembly The propane gas and cylinder are sold separately. Use a standard 1.02 lb. propane cylinder only. 7 Store the appliance indoors only if the cylinder is disconnected and removed from the appliance. A cylinder must be stored outdoors in a well-ventilated area out of the reach of children. A disconnected cylinder must have dust caps tightly installed and must not be stored in a building, garage or any other enclosed area.
PAGE 9
ASSEMBLY INSTRUCTIONS Move the burner control knob to the off position. Fix the 1.02 lb. propane cylinder to the regulator (rotate the propane cylinder clockwise toward the regulator connecting until tight). Close the door plate and lock it with the handle. Disconnect the cylinder when the appliance is not used. Store the appliance indoors only if the cylinder is disconnected and removed from the appliance. You may place the appliance in a shelter: (a) With walls on all sides, but with no overhead cover.
PAGE 10
OPERATION INSTRUCTIONS Portable Heater Location CEILING 24 in. WALL 1. This portable heater is intended for outdoor use only. Always ensure adequate fresh air ventilation. 2. Always maintain proper clearance to combustible materials: a minimum of 24 in. from the top and 36 in. from the sides 3. Place the heater on a strong and stable table. 4. Never operate the heater in an explosive atmosphere like in areas where gasoline or other flammable liquids or vapors are stored. 36 in.
PAGE 11
OPERATION INSTRUCTIONS Turning ON the Heater HI Pilot 1. Turn on the valve on the gas supply cylinder completely. 2. Firmly press down and turn the variable control knob approximately 45° (counterclockwise). 3. Press down the variable control knob and hold for 20 seconds. While holding down the variable control knob, press the igniter button several times until the pilot flame comes on.After lighting the pilot, wait 15 seconds to heat the thermocouple, before releasing the control knob.
PAGE 12
CARE AND MAINTENANCE Gas odor with extreme yellow tipping of flame. Heater does NOT reach the desired temperature. Heater glow is excessively uneven. Heater makes popping noises. Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles. Carbon deposits may create a fire hazard.
PAGE 13
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Cylinder valve is closed Open valve Blockage in orifice or pilot tube Pilot won’t light Air in gas line Note: Heater operates Low gas pressure with cylinder valve fully open at reduced efficiency below 40ºF (5ºC) Igniter fails Clean or replace orifice or pilot tube Open gas line and bleed it (pressing control knob in) for not more than 1 - 2 minutes or until you smell gas Turn cylinder valve OFF and replace cylinder Use match to light pilot;
PAGE 14
ONE-YEAR LIMITED WARRANTY This product is inspected, tested and carefully packaged to minimize the chance of damage during shipment. If a part (excluding light bulbs and fuses*) within one year from the date of purchase proves to be defective in material or fabrication under normal use, the part will be repaired or replaced. The Company's obligation under the warranty is to replace or repair defective parts at our discretion.
PAGE 15
REPLACEMENT PARTS LIST AA A CC BB FF B G DD FF C D H E F EE PART A B C D E F G H AA BB DESCRIPTION Reflector Emitter Wire Guard Access Panel Base Ring Weight Post with Burner Assembly Heater Housing Castle Nut Reflector Spacer QUANTITY 1 1 1 1 1 1 1 1 3 3 PART CC DD EE FF 15 DESCRIPTION Washer Nut M6 X 20mm Bolt 3/16 in.