Use and Care Manual
1. If your grill will be on a combustible surface, the Ceramic Feet and Stainless Steel Heat Shield (SSHS)
must be used.
2. Place the Feet and Shield in the position you would like the grill.
3. The Feet should be arranged underneath the Shield with equal spacing between them. One should be
placed directly in the center on the back side of the Shield and the other two on the left and right of the
front side. Fig. 1
4. The ceramic Feet and Heat Shield may be replaced with a non-combustible slab. The slab should be a
solid stone or masonry unit (at least 1¼” thick). The recommended dimensions of the slab are at least 16”
square or round. Fig. 2
Unbox the Grill
Ceramic Feet and Heat Shield
1. Cut and remove the plastic bands from the box.
2. Lift o the top of the box.
3. The sides of the box are individually removable.
4. Open the grill and remove the cooking grid and discard the cardboard.
5. Remove other items from their packaging and set aside: Stainless Steel Heat Shield, Ceramic Feet (3pcs.),
Chimney Top, Handle, Grate and Stainless Steel Eciency Plate.
6. The stainless steel heat shield and ceramic feet are packaged separately and are only provided for
built-in applications (These items are not included if grill is purchased with cart)
ASSEMBLY - for Built-in Applications
Page 4
Warning:
If the grill is placed on or near a combustible surface, such as a wood deck, it is the owner’s responsibility to
ensure embers do not escape the grill and ignite the wood. A non-combustible protective pad is recommended
underneath and in front of the lower air control/ash clean out door. 10:00am
Fig.1
Fig.2
Proceed to nal grill assembly on page 6
(Skip assembly for cart application).