Installation Guide

Page 4
ASSEMBLY INSTRUCTIONS
1
2
Attach a leg to the leg connector bracket by carefully guiding the bolts already in place on the table legs (each leg
has two bolts) through the holes in the leg connector bracket. Add a washer and a nut to the end of each bolt
. Repeat on the other three legs.Fig. Hand tighten only. Do not tighten completely.
as
shown in 2
3
After making any necessary adjustments to the alignment of the table legs and the leg connector bracket, use the
hex bolt driver and hex wrench to tighten all nuts and bolts. each bolt and nutmust be tightened a few rev-
olutions at a time. In order to apply equal pressure to all bolt joints, we recommend working in a cross corner (X
fashion). Repeat until all bolts are tight. . Over tightening may strip bolts. Cover all nuts
and bolts with covers.
Note:
Do not over tighten
Place the table top upside down on a flat, non-abrasive surface. Attach a table leg to the table top by using the bolts
and washers as shown in . Guide bolts through holes in the table legs and into the pre-drilled holes in the table
top. Repeat for the other three legs.Hand tighten 2-3 turns only.
Fig.1
Fig.1
Fig.2
FOOT CAP
A
E
G
H
B
F
E
D
C