Installation Guide

LIGHTING INSTRUCTIONS

1. Locate the control and igniter panel. Make sure the

control knob is in the “OFF” position. See Figure 10.

Open the tank door and open the tank valve all the way.

2. Push in the igniter button. You will hear a slight clicking

sound. With the igniter button pushed in, push and turn

the control knob to the “ON” position. The fire should

light within a few seconds. Once the flame is lit, release

the igniter button and continue to hold the control knob

in for 10 to 15 seconds. Release the control knob. The

control knob should pop back out and the fire should

remain lit. Note: If the fire does not light, turn the knob

to the “OFF” position and wait five (5) minutes before

trying again.

3. To turn down the flame, push the control knob in slightly

and turn to the Medium (medium flame) or Low (small

flame).

4.To shut down the fire pit, turn the control knob to the

“OFF” position and turn off the tank valve

Figure 10

MAINTENANCE

The flames should look like those in Figure 11. To

clean the burner, use a soft brush after the burner

and lava rocks have cooled completely. Never

use a vacuum cleaner on the lava rocks. It is

recommended that the lava rocks be stored

indoors during the winter if they will be subjected

to freezing temperatures. The propane cylinder

must be disconnected and removed from the

appliance before the appliance can be stored

indoors.

Figure 11

BATTERIES

Make sure the control knob is in the “OFF” position.

Unscrew the push button cap on the ignition module

located on the control panel to access the battery

compartment. The ignition module requires one AAA size

battery. See Figure 12.

Figure 12