Use and Care Manual

7
INSTALLATION
1. Identify the parts packed in the carton against the parts list. Remove all protective
materials and set parts on a flat, non-abrasive surface.
2. Attach the back panel to the side panels by using four 1/4"x40 mm bolts and washers as
shown in Figure 2. Guide bolts through holes in back panel, into pre-drilled holes in the side
panels. Hand tighten only.
Figure 2
3. Attach the middle support to the side panels by using two 1/4"x15 mm bolts and washers
as shown in Figure 3. Guide bolts through the holes in the middle support, into pre-drilled
holes in the side panels. Hand tighten only.
Figure 3