Use and Care Manual

9
6. Attach the LP support to the door panel by using four 1/4"x15 mm bolts and washers as
shown in Figure 6a. Do not over tighten. Place propane tank onto the LP support as shown
in Figure 6b.
Figure 6a Figure 6b
7. Attach the metal ring (as shown in Figure 7a) pre-fitted with regulator hose which is
connected to the table rim, into the holes in the door panel, then use the hex bolt driver to
tighten the 1/4"x5mm nuts. The propane tank is affixed as shown in Figure 7b. Connect
the regulator as shown in Figure7b. Turn the black handle clockwise to tighten. Turn the
handle counterclockwise to remove. The hose must point down. Check that the valve is
turned all the way clockwise to the "OFF" position.
8. After making any necessary adjustments to the alignment of the parts, use the hex bolt
driver to tighten all bolts. Note: each bolt must be tightened a few revolutions at a time.
Figure 7a
Figure 7b