Use and Care Manual

10
Repeat until all bolts are tight. Do not over tighten. Over tightening may strip bolts. Cover all
bolts with covers.
9. Note the clear bumpers spaced evenly throughout the inside of the table rim. Carefully
place tiles inside table rim, resting on the clear bumpers as shown in Figure 8
Figure 8
10. Pour the fire ice into the burner completely covering the burner. See Figure 9. Remove
the cardboard cover from the ignition well.
Figure 9
11. Open the tank valve. Apply a solution of soapy water to the tank-regulator connection
and to the valve-hose connection to check for leaks as shown in Figure 10. If soap bubbles
continue to form, the connection has a leak. If a leak is found, close the tank valve and
tighten all connections.
NOTE: NEVER USE A FLAME TO CHECK FOR LEAKS.
Checking the tank-regulator for leaks
Figure 10