Use and Care Manual

12
Step 5- Stick the conversion label on the rating plate as shown in Figure 11.
1.
2.
3.
4.
5.
6.
7.
Figure 11 Conversion Label
LIGHTING INSTRUCTIONS
Warning: If these instructions are not followed exactly, a fire or explosion may result in
causing property damage, personal injury or loss of life.
1. Make sure the control knob is in the "OFF" position. See Figure 12. Open the tank
valve all the way.
2. Push in the igniter button. You will hear a slight clicking sound. With the igniter button
pushed in, push and turn the control knob to the “ON” position. The fire should light
within a few seconds. Once the flame is lit, release the igniter button and continue to hold
the control knob in for 10 to 15 seconds. Release the control knob. The control knob
should pop back out and then remain lit.
Note: If the fire does not light, turn the knob to the “OFF” position and wait five (5)
minutes before trying again.
3. To turn down the flame, push the control knob in slightly and turn to Medium (medium
or Low (small flame).
IGNITER BUTTON CONTROL KNOB
Figure 12
Serial Number _________________ Model Number: 99300
CAUTION: The gas pressure regulator provided with this appliance must be used. This regulator is set for an outlet pressure of
Minimum clearance from combustible constructions: Sides: 24 in.609 mm. Top 72 in. 1828 mm.
FOR OUTDOOR USE ONLY. If stored indoors, detach and leave cylinder outdoors.
This appliance has been converted to use Natural Gas. Input 30,000 Btu/hr.
Max Gas Supply Pressure 7 inch w.c. (1.74 kPa) Min. Gas Supply Pressure 5 inch w.c. (1.24 kPa)