Instructions / Assembly

7
INSTALLATION
1.Identify parts packed in carton against the parts list. Remove all protective materials
and set parts on a flat, non-abrasive surface.
2.Attach the back panel to side panels by using four 1/4"x45 mm bolts and Ø6.5x1.0 mm
washers as shown in Figure 2. Guide bolts through holes in back panel, into pre-drilled
holes in the side panels. Hand tighten only.
Figure 2
3.Attach the middle support to side panels by using four 1/4"x30 mm bolts and Ø6.5X1.0
mm washers as shown in Figure 3. Guide bolts through holes in the middle support, into
pre-drilled holes in the side panels. Hand tighten only.
Figure 3