Full Product Manual

IMPORTANT SAFETY INFORMATION
The installation must conform with local codes or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA 54; International Fuel Gas Code. ; Natural
Gas and Propane Installation Code, CSA B149.1; or Propane Storage and Handling Code,
B149.2, as applicable.
The appliance must be isolated from the gas supply piping system by closing its
equipment shutoff valve during any pressure testing of the gas supply system at test
pressure equal to or less than 1/2 psi (3.5kPa).
The appliance area must be kept clear and free from combustible materials, gasoline and
other flammable vapors and liquids.
Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect the appliance and to replace any part of the control system
and any gas control which has been under water.
Children and adults should be alerted to the hazards of high surface temperatures
and kept at a safe distance to avoid burns or clothing ignition.
Young children should be carefully supervised when they are anywhere near the
appliance.
Clothing or other flammable material should not be hung from the appliance, or
placed on or near the appliance.
Any screen or guard removed for servicing an appliance must be replaced prior to
operating the appliance.
Installation and repair should be done by a qualified service person. The appliance
should be inspected before use and at least annually by a professional service
person. More frequent cleaning may be required as necessary. It is imperative that
the control compartments, burners and circulating air passageways of the
appliance be kept clean.
Do NOT burn solid fuels in this gas fireplace.
CAUTION: The propane gas pressure regulator provided with this appliance must be
used. This regulator is set for an outlet pressure of 11 inches water column.
This outdoor gas appliance is not intended to be installed in or on recreational vehicles
and/or boats.
Before each use of this gas appliance, open the LP (Liquid Propane) Tank Drawer and
inspect the LP Hose. If there is evidence of excessive abrasion or wear, or the hose is cut,
it must be replaced prior to the gas appliance being put into operation. Use only the
replacement hose assembly specified in this manual. Inspect the burner before each use
of the appliance. The burner must be replaced prior to the appliance being put into
operation if it is evident that the burner is damaged. Use only the burner listed in these
instructions.
Keep the fuel supply hose away from any heated surfaces.