Full Product Manual

5. Put the door onto the bottom connector, guide the pin in the bottom connector into the
hole on the underside of the door. Then guide the pin on the top connector into the hole in
the topside of the door, use a 1/4"x15 mm bolt and washer to attach this top connector to
the right side panel as shown in
Figure 5. Do not over tighten.
Figure 5
6. With the help of another person, carefully place the table top onto the table base. After
making any necessary adjustments to the alignment of the table top and the assembled
base, use four 1/4"x20 mm bolts and washers as shown in Figure 6.Guide the bolts
through the holes in the base, into the pre drilled holes in the table top. Do not tighten
completely.
Figure 6