Installation Guide

9
6. Attach the bottom panel to the back panel by using two 1/4"x30 mm bolts
and washers as shown in Figure 6. Guide the bolts through holes in the bottom
panel, into pre-drilled holes in the back panel. Hand tighten only.
Figure 6
7. Attach the two support bars to the firepan/burner assembly by using two
1/4"x30 mm bolts and washers as shown in Figure 7. Hand tighten only.
Figure 7
8. Attach the complete firepan/burner assembly to back panel with door panel
by using four 1/4"x20 mm bolts and washers as shown in Figure 8. Hand
tighten only.
Figure 8