Installation Guide

Page 4
ASSEMBLY INSTRUCTIONS
1
2
3
Assemble furniture on a smooth, non-abrasive surface. by using two
1/4"x18 mm bolts and washers as shown in Fig.1. Guide the bolts through holes in back frame, into
pre-drilled holes in the . Hand tighten only. and back frame
by using four mm bolts and washers as shown in Fig.2. Hand tighten only. A
and seat frame by using four mm bolts and four washers as shown in Fig.3. Hand tighten
only.
Attach the back frame to right arm
right arm Attach the seat frame to right arm
ttach the left arm
to back
1/4"x18
1/4"x18
B
Fig.1
A
Fig.2
C
Fig.3
Attach the complete base to the complete seat by using four 5/16"x40 mm bolts and washers as shown
in Fig.4. Guide the bolts through holes in base, into the pre-drilled holes in the seat. Hand tighten only.
Using the hex bolt driver provided, tighten all bolts. Do not over tighten bolts. If nuts and bolts are
too tight or too loose, the glider will not function properly. Test the operation of glider. Gliding
motion should be smooth. Adjust tension on the glider brackets, nuts and bolts as needed. Cover nuts
and bolts with covers provided.
H
F
G
Fig.4
E
D
K
I
J
K
I
J
K
I
J
K
I
J