Installation Guide

Assembly Steps:
Note: Do not fully tighten bolts until assembly is completed and alignment is correct.
Step 1. Carefully place the table top (A) upside down on a non-abrasive surface.
Step 2. Assemble the table legs (B) to the table top (A) with bolts (AA) and washer (CC)
as shown in figure 1.
Figure 1
Step 3. Assemble connector (C) to the table leg (B) with bolts (BB) and washer (CC)
as shown in figure 2.
Step 4. Tighten all bolts with wrench (EE) . Cover all bolts with bolt caps(DD).
Figure 2
Page 6 of 7