Use and Care Manual

BATTERIES

Make sure the control knob is in the "OFF" position. Unscrew the

push button cap on the ignition module located on the control panel

to access the battery compartment. The ignition module requires

one Alkaline AA size battery (1.5V). The negative (-) end goes in

first. See Figure 7.Dispose of battery safely. May explode or leak if

charged or disposed of in fire. Make sure of the polarity. Mercury

and cadmium free.

CAUTIONS: BATTERY INSTRUCTIONS

●Always purchase the correct size and grade of battery most suitable for the intended use.

●Always replace the whole set of batteries at one time, taking care not to mix old and new ones, or batteries of different

types.

●Clean the battery contacts and also those of the device prior to battery installation.

●Ensure the batteries are installed correctly with regard to polarity (+ and -).

●Remove batteries from equipment which is not to be used for an extended period of time.

●Remove used batteries promptly.

For recycling and disposal of batteries to protect the environment, please check the internet or your local phone directory

for local recycling centers and / or follow local government regulations.

LIGHTING INSTRUCTIONS

Warning: If these instructions are not followed exactly, a fire or explosion may result

causing property damage, personal injury or loss of life.

1. Open the tank drawer and find the control panel on the left. Make sure the control knob

is in the "OFF" position. See Figure 8. Open the tank valve all the way.

2. Push in the igniter button. You will hear a slight clicking sound. With the igniter button

pushed in, push and turn the control knob to the “ON” position. The fire should light

IGNITER BUTTON CONTROL KNOB

Figure 8

Figure 7