Use and Care Manual

within a few seconds. Once the flame is lit, release the igniter button and continue to

hold the control knob in for 10 to 15 seconds. Release the control knob. The control

knob should pop back out and then the fire remain lit. Note: If the fire does not light, turn

the knob to the “OFF” position and wait five (5) minutes before trying again.

3. To turn down the flame, push the control knob in slightly and turn to Medium (medium

flame), or Low (small flame).

4. To shut down the fire pit, turn the control knob to the “OFF” position and turn off the tank

valve.

TROUBLESHOOTING GUIDE

PROBLEM CAUSE REMEDY

No Propane Gas at Burner

Check that gas tank valve is

open. Turn control knob to “ON”

and push control knob in. Make

sure tank has propane gas.

No Spark at Electrode

Check that AAA battery is

installed with negative (-) end

first and has a charge. Check

that the wire is connected to the

ignition module. Check that the

electrode is not cracked or

broken.

Burner won’t light

Lack of oxygen

Remove excess lava rocks or fire

ice from around the ignition well.

Thermocouple not in flame

Check that the tip of the

thermocouple is even with the

top of the ignition well. Remove

any lava rocks from the ignition

well.

Thermocouple connection

at the main control valve is

loose.

Tighten the thermocouple nut at

the back of the valve.

Burner won’t stay

lit after lighting

No lava rocks on burner

Cover the burner with lava rocks

per the instructions.