Use and Care Manual

6
INSTALLATION
1. Carefully unpack all items from the box. Place the base in the final position. There must be
a minimum of 24 in / 60.96 cm of clearance from the side of the table top to any combustible
walls.
2. Pour ALL the provided media (fire ice or lava rock) into the burner pan. Burner MUST be
completely covered to ensure appliance function properly and safely. Remove any lava rocks
or fire ice on top of the ignition well. See Figure 3.
Figure 3
3. Slide the tank drawer out and place the LP tank in the drawer. Connect the regulator as
shown in Figure 4. Turn the black handle clockwise to tighten. Turn the handle
counterclockwise to remove. The hose must point down. Check that the valve is turned all the
way clockwise to the "OFF" position. Open the tank valve. Apply a solution of soapy water to
the tank-regulator connection and to the valve-hose connection to check for leaks. If soap
bubbles continue to form, the connection has a leak. If a leak is found, close the tank valve
and tighten all connections.
NEVER USE A FLAME TO CHECK FOR LEAKS.
Figure 4