Use and Care Manual

IMPORTANT SAFETY INFORMATION ABOUT
PROPANE (LP) GAS
A LP-gas cylinder for use with this appliance must have a capacity of 20 lbs / 9kg.
and must be equipped with a Type 1 connector and an OPD (overfill protection
device). Figure 1
The LP-gas supply cylinder to be used must be constructed and marked in
accordance with the specification for LP-gas cylinders of the U.S. Department of
Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339,
Cylinder, Sphere and Tubes for the Transportation of Dangerous Goods.
 The cylinder supply system must be arranged for vapor withdrawal.
 The cylinder used must include a collar to protect the cylinder valve.
 This appliance shall be used only outdoors in a well-ventilated space and shall
not be used in a building, garage or any other enclosed space.
 When this appliance is not in use, the gas must be turned off at the supply
cylinder.
 Storage of this appliance indoors is permissible only if the cylinder is
disconnected and removed from the appliance.
 Cylinders must be stored outdoors in a well-ventilated area out of the reach of
children. Disconnected cylinders must have threaded valve plugs tightly
installed and must not be stored in a building, garage or any other enclosed
areas.
CSA (Canadian Standards Association) certified to ANSI Z21.97-2014 / CSA
2.41-2014 “Outdoor Decorative Gas Appliances”
Figure 1
SPECIFICATIONS
INPUT 30,000 Btu/hr
Propane Regulator
Pressure
11 in / 2.74 kPa water column
Natural Gas Minimum
Inlet Pressure
7 in / 1.74 kPa water column
Clearances to
combustible surfaces
Sides 24 in / 60.96
cm
Top: 72 in / 182.88 cm
Page 7